Keysight N6705 Service Manual page 129

Command Errors (continued)
108 Parameter not allowed
More parameters were received than were expected.
109 Missing parameter
Fewer parameters were received than were expected.
110 Command header error
An error was detected in the header.
Header separator error
111
A character that was not a valid header separator was found in the command string.
Program mnemonic too long
112
The header contains more than 12 characters.
Undefined header
113
A command was received that was not valid for this instrument.
114 Header suffix out of range
The value of the numeric suffix is not valid.
120 Numeric data error
Generic numeric data error.
121 Invalid character in number
An invalid character for the data type was found in the command string.
123 Exponent too large
The magnitude of the exponent was larger than 32000.
124 Too many digits
The mantissa of a numeric parameter contained more than 255 digits, excluding leading zeros.
128 Numeric data not allowed
A numeric parameter was received but a character string was expected.
130 Suffix error
Generic suffix error
131 Invalid suffix
A suffix was incorrectly specified for a numeric parameter.
134 Suffix too long
The suffix contains more than 12 characters.
138 Suffix not allowed
A suffix is not supported for this command.
140 Character data error
Generic character data error
141 Invalid character data
Either the character data element contains an invalid character, or the element is not valid.
144 Character data too long
The character data element contains more than 12 characters.
148 Character data not allowed
A discrete parameter was received, but a string or numeric parameter was expected.
String data error
150
Generic string data error
Invalid string data
151
An invalid character string was received. Check that the string is enclosed in quotation marks.
String data not allowed
158
A character string was received, but is not allowed for this command.
160 Block data error
Generic block data error
161 Invalid block data
The number of data bytes sent does not match the number of bytes specified in the header.
Model N6705 Service Guide
Error Messages Appendix A
129