Login - HPE XP7 User Manual

By default, the interval between one retry and the next retry is two minutes. You can change the
interval by using the retry subcommand.
The retry subcommand must run before the login subcommand runs.
Syntax
retry [time=m] [count=n]
Operands
Operand
time=m
count=n
Example
If the following command file is used, the interval between retries is 5 minutes and the maximum
number of retries is 10.
svpip 158.214.135.57 retry time=5 count=10login expusr passwd
show group Portshort-range 201304010850:201304010910outpath
outoption compressapply

login

Description
This subcommand uses a user ID and a password to log the specified user in SVP.
The svpip subcommand must run before the login subcommand runs.
The login subcommand fails if monitoring data does not exist in SVP.
Syntax
login userid password
Operands
Operand
userid
password
Example
This example logs the user expusr into SVP whose IP address is 158.214.127.170. The password
is pswd.
Description
Specifies the interval between retries in minutes, where m is a value within the range of 1 to
59.
If this operand is omitted, the interval between retries is two minutes.
Specifies the maximum number of retries.
If n is 0, the number of retries is unlimited.
If this operand is omitted, the maximum number of retries is 3.
Description
Specifies the user ID for SVP.
If the user ID includes any non-alphanumeric character, the user ID must be enclosed by
double quotation marks (").
Be sure to specify a user ID that is used exclusively with Export Tool. For detailed information,
see "Requirements for Export Tool" (page
Specifies the password of the user.
If the password includes any non-alphanumeric character, the password ID must be enclosed
by double quotation marks (").
50).
Export Tool command reference 63