HPE XP7 User Manual page 123

9. In the Add WWN window, specify the WWN and the PFC name.
Expand the WWN list to show the WWNs of the host bus adapters that are connected to the
port but are not monitored. These host bus adapters are the same as that displayed in step
7. From that list, select a WWN and specify the PFC name (up to 64 characters).
NOTE: It is recommended that you specify the same names for the PFC names and the
host bus adapter nicknames defined in LUN Manager for convenience of host bus adapter
management. In the Performance Monitor window, both the PFC names and the nicknames
are displayed as the aliases of host bus adapters (WWNs), so if you use the same names,
management of the host bus adapters is easier.
10. Click OK. The selected WWN (of the host bus adapter) is moved from Non-Monitor to
Monitor.
If the specified host bus adapter is connected to other ports, after clicking OK, a message
appears asking whether to change the settings of that host bus adapter for other ports. Apply
the same setting to all of the ports.
11. Repeat steps 8 to 11 to move all host bus adapters from below Non-Monitor to below
Monitor.
Up to 32 host bus adapters (WWNs) can be monitored for one port. If more than 32 host
bus adapters are connected to one port, the traffic statistics for all host bus adapters cannot
be monitored. Consider the intended use of each host, and place the host bus adapters that
do not need to be monitored below Non-Monitor.
NOTE: When you disconnect a host that has been connected via a cable to your storage
system or change the port to the another port of the host, the WWN for the host will remain
in the WWN list on the WWN tab. To remove the WWN from the list, you need to delete the
WWN using LUN Manager. For details, see the XP7 Provisioning for Open Systems User
Guide.
12. In the Performance Control main window click Apply to apply the settings to the storage
system.
13. If you add a port or a host bus adapter to the storage system after the settings above, the
traffic for the new port or host bus adapter will not be monitored. In this case, follow this
procedure again to make sure all traffic between host bus adapters and ports is being
monitored.
Implementing Performance Control: many-to-many connections 123