Table of Contents
Advertisement
User Manual of Thermal Bi-spectrum Network Speed dome
Chapter 5System Configuration
5.1 Storage Settings
Before you start:
To configure record settings, please make sure that you have the network storage device
within the network or the memory card inserted in your speed dome.
5.1.1 Configuring Recording Schedule
Purpose:
There are two kinds of recording for the speed domes: manual recording and scheduled
recording. In this section, you can follow the instructions to configure the scheduled
recording. By default, the record files of scheduled recording are stored in the memory
card (if supported) or in the network disk.
Steps:
1. Enter the Record Schedule settings interface:
Configuration > Storage > Schedule Settings > Record Schedule
2. Check the checkbox of Enable to enable scheduled recording.
3. To set the advanced settings of the speed dome, click
advanced settings interface.
© Hikvision
www.a1securitycameras.com email: sales@a1securitycameras.com
Figure 5-1 Recording Schedule Interface
Available from A1 Security Cameras
35
to enter the
Advertisement
Table of Contents
