Table of Contents
Advertisement
User Manual of Thermal Network Speed dome
Task 2.
For two alarm rules of frame, you can set the alarm for region temperature
difference.
a) Set the frame alarm rules.
b) Click
difference alarm interface.
Figure 5-31 Region Temperature Difference Alarm
c) Select two rules to compare the saved regions.
d) Set the alarm rules and the temperature.
E.g., select Alarm Rule as Temperature Difference is Higher than, and enter
10 ° C, the device alarms when the difference between the minimum
temperature and the maximum temperature of the region is higher than 10 ° C.
Temperature Difference Alarm only applies to the targets set by frame.
3. Set Alarm Linkage: Click Alarm Linkage to enter the alarm linkage interface and set the
linkage methods. Refer to Step 3 in Section 5.2.1 Configuring Motion Detection. In the
field of Other Linkage, you can check the checkbox to enable the alarm output (The
alarm output number varies depending on device ability).
4. Click
© Hikvision
www.a1securitycameras.com email: sales@a1securitycameras.com
to save the settings.
Available from A1 Security Cameras
to show the region temperature
64
Advertisement
Table of Contents
