Table of Contents
Advertisement
User Manual of Thermal Network Speed dome
Set the
2.
HTTP port, RTSP port and port of the speed dome.
HTTP Port: The default port number is 80.
RTSP Port: The default port number is 554.
HTTPS Port: The default port number is 443.
Server Port: The default port number is 8000.
3. Click
Configuring NAT (Network Address Translation) Settings
Purpose:
Universal Plug and Play (UPnP™) is a networking architecture that provides compatibility
among networking equipment, software and other hardware devices. The UPnP protocol
allows devices to connect seamlessly and to simplify the implementation of networks in
the house and corporate environments.
With the function enabled, you don't need to configure the port mapping for each port, and
the camera is connected to the Wide Area Network via the router.
Steps:
1. Enter the UPnP™ settings interface.
Configuration >Network > Basic Settings > NAT
2. Check the checkbox to enable the UPnP™ function.
You can edit the Friendly Name of the speed dome. This name can be detected by
corresponding device, such as a router.
3. Set the port mapping mode:
To port mapping with the default port numbers:
Choose
To port mapping with the customized port numbers:
Choose
And you can customize the value of the port number by yourself.
4. Click
© Hikvision
www.a1securitycameras.com email: sales@a1securitycameras.com
to save the settings.
Figure 7-9 Port Mapping Mode
to save the settings.
Available from A1 Security Cameras
81
Advertisement
Table of Contents
