User Manual of Thermal Network Speed dome
3. Check Enable checkbox to enable the tampering detection.
4. Click
arming schedule configuration is the same as the setting of the arming schedule for
motion detection. Refer to Section 5.2.1 Configuring Motion Detection.
5. Click
surveillance center, send email and trigger alarm output are selectable. Refer to Section
5.2.1 Configuring Motion Detection.
6. Click
5.2.3 Configuring Alarm Input
Steps:
1. Enter the Alarm Input settings interface:
Configuration > Event > Basic Event > Alarm Input
2. Choose the alarm input No. and the Alarm Type. The alarm type can be NO (Normally
Open) and NC (Normally Closed).
3. Edit the name in
alarm input (optional).
© Hikvision
www.a1securitycameras.com email: sales@a1securitycameras.com
Figure 5-15 Tampering Alarm
tab to enter the arming schedule setting interface. The
tab to select the linkage method taken for tampering, notify
to save the settings.
Available from A1 Security Cameras
47
to set a name for the