Table of Contents
Advertisement
User Manual of Thermal Network Speed dome
Configuration > PTZ > Basic Settings
Figure 7-26 Basic PTZ Configuration Interface
2. Configure the following settings:
Basic Parameters: Enable/disable PTZ control, proportional pan and preset freezing,
set the preset speed, keyboard control speed, and auto scan speed.
PTZ Control: By default, PTZ Control function is enabled .You can uncheck the
checkbox to disable the PTZ control function.
The PTZ Control function varies depending on the models of speed dome.
Proportional Pan: If you enable this function, the pan/tilt speeds change according
to the amount of zoom. When there is a large amount of zoom, the pan/tilt speed
will be slower for keeping the image from moving too fast on the live view image.
Preset Freezing: This function enables the live view to switch directly from one
scene defined by a preset to another, without showing the middle areas between
these two, to ensure the surveillance efficiency. It can also reduce the use of
bandwidth in a digital network system.
Preset freezing function is invalid when you calling a pattern.
Preset Speed: You can set the speed of a defined preset from 1 to 8.
Manual Control Speed: The speed dome provides 5 control speed modes:
Compatible, Pedestrian, Non-motor Vehicle, Motor Vehicle and Auto. Select it from
the dropdown list.
Keyboard Control Speed: Define the speed of PTZ control by a keyboard as Low,
Medium or High.
© Hikvision
www.a1securitycameras.com email: sales@a1securitycameras.com
Available from A1 Security Cameras
95
Advertisement
Table of Contents
