Table of Contents
Advertisement
User Manual of Thermal Network Speed dome
2. Configure the NIC settings, including the IPv4(IPv6) Address, IPv4(IPv6) Subnet Mask
and IPv4(IPv6) Default Gateway.
3. Click
You can click Test to make sure that the IP address is valid.
If the DHCP server is available, you can check
address and other network settings from that server.
The valid value range of Maximum Transmission Unit (MTU) is 500 ~ 1500. The
default value is 1500.
The Multicast sends a stream to the multicast group address and allows multiple
clients to acquire the stream at the same time by requesting a copy from the
multicast group address.
Before utilizing this function, you have to enable the Multicast function of your router
and configure the gateway of the network speed dome.
If the DNS server settings are required for some applications (e.g., sending email), you
should properly configure the Preferred DNS Server and Alternate DNS server.
The router must support the route advertisement function if you select Route
Advertisement as the IPv6 mode.
Configuring DDNS Settings
Purpose:
If your speed dome is set to use PPPoE as its default network connection, you can use the
Dynamic DNS (DDNS) for network access.
Before you start:
Registration on the DDNS server is required before configuring the DDNS settings of the
speed dome.
For your privacy and to better protect your system against security risks, we strongly
recommend the use of strong passwords for all functions and network devices. The
password should be something of your own choosing (using a minimum of 8
characters, including upper case letters, lower case letters, numbers and special
characters) in order to increase the security of your product.
© Hikvision
www.a1securitycameras.com email: sales@a1securitycameras.com
to save the above settings
Figure 7-2 DNS Server Settings
Available from A1 Security Cameras
.
to automatically obtain an IP
77
Advertisement
Table of Contents
