Table of Contents
Advertisement
User Manual of Thermal Network Speed dome
(1) Check the radio button to enable the NTP function.
(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions by NTP server. It
can be set from 1 to 10080 minutes.
You can click
to make sure that the NTP server is connected.
If the speed dome is connected to a public network, you should use a NTP server that
has a time synchronization function, such as the server at the National Time Center
(IP Address: 210.72.145.44). If the speed dome is set in a customized network, NTP
software can be used to establish a NTP server for time synchronization.
Configuring Time Synchronization Manually
Steps:
(1) Check the Manual Time Sync radio button.
(2) Click
to set the system time from the pop-up calendar.
(3) Click
You can also check the Sync with local time checkbox to synchronize the time of the
speed dome with the time of your computer.
Select the Time Zone
© Hikvision
www.a1securitycameras.com email: sales@a1securitycameras.com
Figure 7-60 Time Sync by NTP Server
to save the settings.
Figure 7-61 Time Sync Manually
Available from A1 Security Cameras
120
Advertisement
Table of Contents
