Table of Contents
Advertisement
User Manual of Thermal Network Speed dome
You can configure the Notify Surveillance Center function which is used for
uploading the picture to the surveillance center when and VCA alarm occurs.
You can also set the quality and resolution of the picture separately.
5. Click
6.2 Advanced Configuration
All the parameters for both behavior analysis and face capture are collected in the
advanced configuration page. You can configure these parameters for different VCA types
on your demand.
Steps:
1. Enter the Advanced Configuration interface:
Configuration > VCA > Advanced Configuration
2. Adjust the Detection Parameters.
Detection Sensitivity: Range [0-4], the higher the sensitivity is, the easier the target will
be detected.
Background Update Rate: Range [0-4], if a detected target remains in the monitoring
scene for a certain time, the system will count the target as the background
automatically. The greater the value is, the faster the target will be counted as the
background.
Minimum Target Size: Range [0-4], The system will filter out the object smaller than
the minimum target size.
© Hikvision
www.a1securitycameras.com email: sales@a1securitycameras.com
to save the settings.
Figure 6-2 Advanced Configuration
Available from A1 Security Cameras
66
Advertisement
Table of Contents
