Table of Contents
Advertisement
User Manual of Thermal Network Speed dome
2. Set the compass parameters.
(1) Select PT Mode as Manual.
(2) Click the PTZ control buttons to find the north direction; you can also call a
defined preset and set it as the north direction.
(3) Click Set as North to save the position.
(4) Optionally, you can click Point to North to move the device to the north direction
if the north direction was once saved.
3. Set the vandal-resistance alarm.
(1) Slide the bar to adjust the sensitivity of vandal-resistance detection.
(2) Check the checkbox of Upload Vandal-Resistance Alarm to upload the
vandal-resistance alarm.
(3) Check the checkbox of Enable Vandal-Resistance Alarm Voice Warning to
enable the voice warning of vandal-resistance alarm.
4. Set GPS settings.
(1) Select Longitude-Latitude Mode as Manual.
(2) Select longitude and latitude as East or West according to the actual position.
(3) Enter the value of longitude and latitude in three textboxes.
5. Click
© Hikvision
www.a1securitycameras.com email: sales@a1securitycameras.com
Figure 7-37 Position Settings
to save the settings.
Available from A1 Security Cameras
103
Advertisement
Table of Contents
