Rf260X Commands - Siemens SIMATIC Ident System Manual

Accessories
8.2 Antenna multiplexer SIMATIC RF260X
Note
Changing the parameter assignment
• Note that if you change the parameter settings of the reader or the RF260X in scanner
mode, this may lead to frame collisions. These collisions result when the frame is sent
while a transponder is present.
• The "Transponder response time" (setting: "CFG2: COM interface") during operation of
the RF260X must be higher than the total delay time for all the connected antennas
(CFG15: MUX-VALD-TIME × Number of Output Channels ≤ Transponder Response
Time)
8.2.8

RF260X commands

Using the tool "RF290R-Set" (V9.5.2), certain commands can also be sent to the RF260X. In
the "Commands" menu under "RF260X", the following commands can be sent:
● Detect (detection of the RF260X by the reader)
● Channel Select (set to a static channel)
● CPU-Reset (restart the RF260X software)
● Software Version (read out software and hardware versions)
Figure 8-4
246
Sending commands from the "RF290R-Set" tool
System Manual, 09/2013, J31069-D0227-U001-A8-7618
SIMATIC RF200