Mitsubishi MOTORS M.U.T.-III Owner's Manual page 91

In case of Engine ECU
Part# MD351868
ROM-ID 120926
Auto change in 4 sec*
Press Enter to
Reprogram ECU
In case of PCM (Engine & A/T ECU)
ENG P/N MD351868
R-ID 120926
Auto change in 4 sec*
AT P/N MD351868
R-ID B53500
Auto change in 4 sec*
Press Enter to
Reprogram ECU
Auto change in 4 sec*
RPG data doesn't
apply to ECU
Auto change in 4 sec
Part# MD351868
ROM-ID 120926
Auto change in 4 sec
CK VCI for
correct RPG data
Auto change in 4 sec
ECU same as VCI
CK for new data
Auto change in 4 sec
Part# MD351868
ROM-ID 120926
Auto change in 4 sec
Turn IG SW OFF,
please wait...
Auto change in 4 sec
Reprogramming Operation ( V.C.I. alone )
9-4-4. Reprogramming ECU (V.C.I. --> Vehicle ECU)
(1) ECU parts No. and ROM-ID No. are displayed.
Press Enter key to start reprogramming.
ESC /
* : By pressing
Note:
- Reprogramming must carry out on the condition of engine
stop and IG switch on.
- Do not disconnect harness/ turn off the IG switch during
ECU reprogramming.
[Messages before/during reprogramming process]
a) "RPG data doesn't apply to ECU"
Reprogramming stopped owing to the data in V.C.I. memory
being not appropriate for the ECU.
• Note down the displayed ECU parts No. and ROM-ID.
• Restart V.C.I. by pressing Enter key, and confirm the
matching of the data file No, which is displayed by reboot,
and the ECU part No./ ROM-ID for reprogramming.
b) "ECU same as VCI, CK for new data" (CK; check)
Reprogramming stopped because reprogramming has been
already done.
key : restart V.C.I.
key, immediately move to next.
84