Mitsubishi MOTORS M.U.T.-III Owner's Manual page 132

Troubleshooting Procedures on VCI Firmware Update
NOTE
* Re-update of The Firmware of V.C.I. (Can not re-update the firmware of V.C.I., if the firmware of V.C.I. is
normal.)
1. Boot PC installed M.U.T.-III.
2. Start M.U.T.-III.
3. Click "STV" button. (Ignore this step in US)
-> Diagnosis main menu will be displayed.
4. Click "System Select" button.
-> System select menu will be displayed.
5. Connect PC with USB cable.
6. Dis-connect V.C.I. with all connector.
7. While pressing the "ESC" button of V.C.I., connect V.C.I. by USB cable to PC.
8. Confirm "Maintenance Mode" is displayed on the screen of V.C.I..
(Re-execute step 7 if "Maintenance Mode" is not displayed in the screen of V.C.I..)
9. Release "ESC" button of V.C.I..
10. Click "OK" button in system select menu of M.U.T.-III.
11. Since the dialog of "V.C.I. Setup" will be displayed click "OK" button in this dialog.
12. Wait to re-update firmware of V.C.I. since the re-update of firmware of V.C.I. starts. (for about 100
sec)
(The dialog of "device dis-connection" will be displayed when the re-update of firmware of V.C.I.
started and when finished. Click "O.K." button on the dialog to close the dialog.)
125