Mitsubishi MOTORS M.U.T.-III Owner's Manual page 135

No. Message
During Automatic RPG with V.C.I.
alone.
No response from
6
vehicle ECU
During Automatic RPG with V.C.I.
alone.
CK VNxxxxx.rpg
7
In PC card
During automatic RPG or Load RPG
with V.C.I. alone.
Load error
8
Message
No.
1
2
3
Troubleshooting of Reprogramming
<Cause>
There is no ECU for requiring reprogramming
IG switch not positioned "ON".
Main Harness not connected.
<Remedy>
1. Turn off the V.C.I. power.
2. Verify the connection of harness, and condition of harness itself.
3. Verify if the ECU for required reprogramming is installed.
4. Verify if the ECU can communicate with V.C.I.
5. Then redo the procedures.
<Cause>
There is no reprogramming data in memory card although ECU is
affected for reprogram.
<Remedy>
1. Press the V.C.I. "Enter" key and back to Main menu.
2. Turn off the V.C.I. and eject the memory card from V.C.I..
3. Insert the memory card into M.U.T.-III (PC), and transfer the data
to the card. Then retry the procedure.
<Cause>
Failure of data transfer from memory card to V.C.I..
<Remedy>
1. Press the V.C.I. "Enter" key and back to Main menu.
2. Retry Automatic RPG or Load RPG again.
13-4-2. Trouble of Reprogramming on CAN communication
< Cause >
・ No reprogramming data exists for selected vehicle.
< Remedy >
・ Select vehicle type again.
< Cause >
・ Model specifying information (Model Year, Type, Class) is
insufficient.
< Remedy >
Select vehicle type again.
< Cause >
・ No CBF file exists in PC.
< Remedy >
・ Reinstall M.U.T.-III.
128
Cause/Remedy
Cause/Remedy