Chapter 6 Drive Recorder; How To Record The Data - Mitsubishi MOTORS M.U.T.-III Owner's Manual

Chapter 6 Drive Recorder

6-1. How to Record the Data

There are two ways for recording the data, "Recording by V.C.I. alone (6-1-1)", and "Recording on
PC with displaying data (6-1-2)". Please select one of them and follow the procedure.
How to Record the Data
6-1-1. Recording by V.C.I. alone
This section describes the operation for recording data
using only V.C.I. without connecting to PC. However, drive
recorder settings such as items to be recorded or trigger
method are configured using PC.
Please connect V.C.I. into PC and the vehicle, and start
performing the following steps using PC first.
(1) System Select
Select a system for which the drive recorder is to be used
on the System Selection screen.
(For instruction on how to select a system, refer to 3-3-1)
- The following explanation describes how to set the drive
recorder settings of the MPI/GDI/DIESEL system as a
representative example.
(2) Function Select
Press Drive Recorder button.
<NOTE>
When a Check Mode button is effective, it's possible to
sample in a short interval when it's changed to a check
mode.
(3) Drive Recorder Function select
Press Record button on the Drive Recorder function menu.
Note:
Data display -- To transfer the recorded data on the V.C.I.
into the PC (refer to 6-2), or display the data (refer to 6-3).
Record (Read Setting Conditions) -- Restore past
recording conditions so that you can execute recording
under the same conditions as those used with previously
recorded data files. (refer to 6-1-3)
Data Storing -- The data saved in a removable disk can
be stored into the PC. (refer to 6-2-2(7))
42