Stand-Alone Diagnosis - Mitsubishi MOTORS M.U.T.-III Owner's Manual

4-4. V.C.I. Stand-alone Diagnosis
This function allows you to read out DTCs by V.C.I. alone, without carrying PC or USB cable into
the vehicle, using a memory card that is storing a diagnostic data transferred from PC.
Once 4-4-1 has been performed, you should precede just 4-4-2 operations until a new database
will be distributed.
V.C.I. Stand-alone Diagnosis
4-4-1. Data transfer to memory card
Transfers the data in hard drive to a memory card.
Please perform this operation after every update of the
database for V.C.I. stand-alone diagnosis.
(1) Insert the memory card (MB992228) into the card adaptor
(MB991939), and then insert them into m-card slot on PC.
Note:
If you use the same memory-card as using for ECU
reprogramming, it may take time to display the next step after
selecting [1.Diagnosis] on V.C.I. LCD menu. (refer to
4-4-2(2)).
(2) Press Special Function button on the STV Top Menu.
(3) Select System Function tab,
then press V.C.I. Stand-alone Diagnosis button.
(4) The version of current data for V.C.I. Stand-alone Diagnosis
is indicated on the left table.
Please select a destination having a box checked (
the right table, then press
30
button to transfer the data.
) on