Mitsubishi MOTORS M.U.T.-III Owner's Manual page 59

(a). Recording screen [Graph]
(b). Recording screen [Text]
How to Record the Data
(14) Recording Data
[Graph]
It saves at the file, expressing data as the set-up record
conditions. The four items chosen on (9) are indicated by
graph as the left screen (a).
[Text]
When "Text" was chosen on (8), and a drive recorder is set
up, it saves at a file, acquiring and expressing data as the
set-up record conditions. (see the left screen (b))
--Data record end -- to (15)
When Trigger is not generated during data record, let the
point at the time of a record start is time 0:00.0.
--Manual Trigger occurs
However, when Diagnosis Code Trigger or Threshold Trigger
are chosen as trigger conditions, suppose that it is invalid.
Note:
-Record is continued until record end button is pushed,
even if trigger occurs.
-The availability of the hard disk of the PC is checked after
record screen display and before record start. When the
availability is 100MB or less, a message is displayed and
record is stopped.
-When the number of record data reaches to 20000 points,
a message is displayed and record is completed.
(15) Save record data
On the screens of (14), pressing
data acquisition and saves it, and then displays a dialog
indicating completion of the record data saving.
-- OK -- to Drive Recorder function select menu screen
(refer to (3)).
Note:
*In the case that there is no record data, a dialog is
displayed confirming whether to stop the recording.
-- OK -- to the drive recorder function select menu
-- Cancel -- to (14) to start recording again.
(16) When you check the recorded data, continue to 6-2-2.
52
button ends the