Mitsubishi MOTORS M.U.T.-III Owner's Manual page 40

Display Example：
<System Select>
MPI/GDI/DIESEL
IMMOBILIZER
ELC-AT/CVT
ABS/ASC/ASTC
TCL
・ ・
・
Display Example:
<Option Select>
ABS
ASC
Display Example:
<Function Menu >
Read DTCs
Erase DTCs
Service Data
Display Example:
<DTCs> 01/10
C1234 RL Weel Sp
C xxxx * Pump Motor
C xxxx Brake Peda
U xxxx * Bus off
・ ・
・
RL Weel Speed Sen
sor Short Circuit
V.C.I. Stand-alone Diagnosis
(5) System Selection
Press button to browse the list until the LCD displays
the system you want to diagnose, then press
button.
(6) Option Selection
If the system has a loading option, the 'Option Select' menu
will be displayed. (If not, go to (7) directly)
Select an option, then press
(7) Function Selection
Select a function, then press
Read DTCs -- Display of the DTCs (to (8))
Erase DTCs -- Erase of the DTCs (to 4-4-3)
Service Data – Display of the Service Data (to 4-4-4)
(8) Display of the DTCs
The DTCs that have been read from ECU are displayed.
-The number shown on the right edge of first line is
indicating [Serial # / Total number of detected DTCs].
-Press button to display the next DTC.
(When having only one DTC, the arrow is not displayed
on the first line.)
-V.C.I. is constantly reading DTCs and updating the display.
-If the system supports status recognition, current status of
each DTC is expressed by the following symbols, which
appears between code and name.
Active
Stored
-Pressing
(To return to the previous screen, press
33
(Enter) button.
: [ ]
(blank)
: [ * ]
(Enter) button shows full name of the DTC.
(Enter)
(Enter) button.
or once.)