Mitsubishi MOTORS M.U.T.-III Owner's Manual page 88

Reprogramming Operation ( V.C.I. alone )
(11) Verify the contents of the selection, then press OK button.
(12) After displayed the message "The device can now be safely
removed from the system", push the lever on the side of PC
card slot and remove the memory card.
Caution:
Do not remove the memory card away unless complete
above method or turn off the PC.
9-4-2. Equipment Set-Up
(1) Insert the Memory card (MB991853, MB992228), which is
storing the reprogramming data, into the Card adaptor
(MB991939) and insert them into V.C.I. main unit
(MB991824)
(2) Connect M.U.T.-III Main Harness B (MB991911) or
A (MB991910) to V.C.I. main unit securely. (refer to 9-2.)
Note:
Select appropriate harness by instruction below.
- Main harness A: For vehicle only equipping 16 pin diagnosis
connector.
- Main harness B: For other vehicles.
- Adaptor harness (MB991855): Outlander, Montero (after
'02MY)
(To connect Main harness B and 13pin diagnosis connector)
(3) After verifying the ignition switch position at LOCK (OFF),
connect the M.U.T.-III Main harness B or A to the diagnosis
connector.
(4) Turn Ignition switch on, and turn V.C.I. main switch on.
(Do not start the engine)
81