Mitsubishi MOTORS M.U.T.-III Owner's Manual page 23

[MPI/GDI/DIESEL 's Function Selection menu]
Check Chart For Problem Symptoms -- To view the Symptom Chart of Service Manual.
Self-diagnosis -- To read out or erase Diagnosis Trouble Codes from vehicle ECU.
Simulated Vehicle Speed Output --To transmit simulated vehicle speed signal into the vehicle.
Data List -- To read the RAM data inside the ECU and displays the data in digital and graphic form.
Actuator Test -- To control the ECU output device. (refer to 4-3.)
Drive Recorder -- To record, display or analyze the ECU input / output signals which can be viewed
Special Function -- To execute special functions specific to the selected system. For detailed
OBD-II Test Mode -- To read out "Monitoring test results" "Provisional DTC" and "ECU information",
Readiness Test -- To read out the result of Readiness Test from ECU.
Voltmeter -- To measure voltage value using M.U.T.-III. (same operation as 11-3-2)
Ohmmeter -- To measure resistance value using M.U.T.-III. (same operation as 11-3-2)
Fuel Pressure Gauge -- To measure fuel pressure using a pressure gauge, and display the result
Check Mode – To shorten sampling time of communication by changing the communication method
Emission Test -- To test the Evaporative Emission Control System of the vehicle.
Coding -- To write the vehicle equipment specifications into ECU.
SWS monitor (appears only when selecting "SWS" system)
Pulse Check
Basic Flow to Start Diagnosis
(4) Function Selection Screen
Also, you can read out the Freeze Frame data. (refer to 4-1.)
using Data List function.
operation other than Chapter 5, please utilize each Online Help function.
which are regarding Emission Related System, from ECU.
on PC screen. (Not Available in US)
between M.U.T.-III and ECU. This function is available in Data List, Drive Recorder,
Actuator Test and Special Function.
(appears only when selecting "SWS" system)
-- To confirm existence of the signal pulse to operate remote system on SWS
communication line.
After System selection, the Function selection menu of the
selected system appears. Select a button that you want to
perform.
In the picture on the left shows the screen appears when the
MPI/GDI/DIESEL system, which is a representative example,
is selected. Details of each buttons are as follows.
Note:
As available functions differ between systems, there might be
functions that will not appear when you select other system.
(refer to Chapter 6)
16
(refer to 4-2.)
(refer to Chapter 7)