Mitsubishi MOTORS M.U.T.-III Owner's Manual page 39

Connect with Main harness A or B
<Main Menu>
1 Diagnosis
2 ECU Reprogram
3 Voltmeter
4 Ohmmeter
<Vehicle Select>
Up to 2005MY
From 2006MY
For EU countries, the options are
classified in "Up to
and "From 2005 MY".
Display Example ：
<Vehicle Select>
OUTLANDER(CW0#)
・ ・
・
Press Enter button
<Model Select>
Z26A
・ ・
・
Press Enter button
<Series Select>
XNLHL6
・ ・
・
Press Enter button
<MY Select>
2006
・ ・
・
Press Enter button
V.C.I. Stand-alone Diagnosis
4-4-2. Reading DTCs by V.C.I. stand-alone
(1) Insert the memory card, which is storing V.C.I. stand-alone
(2) Turn the V.C.I. power ON, and the V.C.I. LCD screen
(3) Press
2004 MY"
(4) As next 'Vehicle Select' menu is displayed, press
diagnosis data, into the card adaptor, then insert them into
V.C.I. main unit.
-Connect the V.C.I. main unit and the diagnosing vehicle
with an appropriate main harness securely.
displays the Main Menu as illustrated on the left.
Confirm that "1. Diagnosis" is displayed, then press
(Enter) button.
Note:
-If the memory card stores no data, the above Main Menu
will not be displayed.
-If the V.C.I. is set on Drive Recorder mode, the LCD
displays Drive Recorder menu screen (refer to 6-1-1(18)).
Please cancel the Drive recorder mode.
button to browse the list until the LCD displays
the appropriate category for the vehicle you are diagnosing,
then press (Enter) button.
-When selecting "Up to 2005 MY" -- go to (5)
-When selecting "From 2006 MY" -- go to (4)
<Common operations for (3)-(7)>
Note:
- The display scrolls in the direction of the arrow displayed
on the first line. To switch the direction, press
button once.
- If you press (Esc) button twice in quick succession,
the screen goes back to the Main Menu.
to browse the list until the LCD displays the vehicle name,
then press (Enter) button.
After vehicle selection, the LCD menu is followed by 'Model
Select', 'Series Select', and 'Model Year Select'. Perform
each selection in the same operation.
Note:
-The options are displayed in alphabetical order.
32
(Esc)
button
go to (6)