Mitsubishi MOTORS M.U.T.-III Owner's Manual page 129

No.
Message/Symptom
The screen "ECU
Reprogramming"
4
appears as soon as
the V.C.I. power is
activated.
The screen
"Drive Recorder [1]
Record error "
5
appears during
recording the Drive
recorder with V.C.I.
alone.
The following message
is displayed.
" Failed to
communication with
6
V.C.I. Check PC-V.C.I.
connection. Refer to
M.U.T.-III Manual for
other solution."
The following message
is displayed.
" Fail to
7
communication with
V.C.I. Check the USB
cable."
Individual Troubleshooting Procedures
Cause
The V.C.I. basic
application has not
been installed.
Communication error
- Contact failure of
USB cable
- PC does not
recognize that the
V.C.I. has been
connected.
- The stand-alone
function of V.C.I. is
being used.
- Have been failed to
update firmware of
V.C.I..
- The "ECU
Reprogramming"
function has not been
finished perfectly.
- Breakdown of USB
cable.
- Breakdown of USB
port of PC.
- V.C.I. driver is
breaking
- The power supplied
to V.C.I. is lack.
(USB hub is used,
etc.)
122
1. Connect the unit to the PC (for power activation)
while pressing the V.C.I. "Esc" key.
2. Verify that the V.C.I. screen display indicates
"Maintenance Mode".
3. In order to install the V.C.I. basic application, using
the automatic version upgrade feature, start the PC
M.U.T.-III diagnostic application and attempt
diagnosis. (refer to 3-3-1)
4. As "Setup V.C.I." dialog box appears on PC screen
during the diagnosis, press
5. When "Update" dialog box disappears on PC
screen, the install is completed.
6. If, once the application has been downloaded and
the V.C.I. power has been reactivated, the "Main
Menu" or "PC Communication" display does not
appear, request inspection.
1. Press the V.C.I. "Enter" key.
2. Verify that the V.C.I. screen display indicates "Drive
Recorder Continue? ", press the "Enter" key or wait
10seconds to start recording again.
Refer to 13-2
Remedy
button.