Commissioning
6.2 Remote commissioning
– Select the Communication tab and configure the communication parameters. The
– Click OK.
3. Set up the COM interface:
– Select Modbus Networks.
– Right-click on the object name SITRANS FC and select Object Properties.
– Select the Communication tab and configure the Modbus address.
– Click OK.
6.2.1.6
Configuring a new device
Note
Clicking on Cancel during an upload from device to SIMATIC PDM will result in some
parameters NOT being updated.
64
transmitters default settings are:
- Transmission rate: 19200 baud
- Parity: even
Figure 6-2
Modbus net object properties
Figure 6-3
Set the Modbus address
FC310 (From firmware 4.0)
Operating Instructions, 06/2018, A5E44036384-AA