Citronix ci5200 Technical & Service Manual page 196

This Error/Warning will be displayed when the temperature drops below the recommended operating
temperature of 32°F (0°C).
Corrective Action:
Move the Printhead to an environment that is above this temperature.
Flush Stop Not Completed
Definition:
This Error/Warning will be displayed anytime the jet shuts off without letting the stop flush complete,
usually when the power was interrupted or turned off.
Corrective Action:
Backflush the nozzle, clean and dry the printhead, and restart the jet.
If the printer is not going to be used, perform a proper shutdown by pressing the power button and press
[OK] to allow the jet to flush and then power off automatically OR press the [Stop] button and wait until
the jet indicator states "Off", then turn off the power.
Power Off Before Jet Stop
Definition:
If at any time the power is cut off or removed from the printer before a proper shutdown is completed, this
error/fault will be displayed.
Corrective Action
Perform a Backflush of the nozzle and start the jet (see Section 6 Sub-section "Backflush Routine"). If the
printer is not needed, press the Stop
Then power can be turned off the printer (unless the printer is a Pigment or Heavy Pigment machine,
these printers should not have the power turned off). You can also (while the jet is running) press the
power button. The printer firmware will prompt you to confirm (by pressing OK) that you want to shut off
the jet. Once this is acknowledged the printer will automatically perform a flush and then turn the power
off.
Version 0.1
ci5000 Series Printer Technical Service Manual
button and allow the printer to perform a complete shutdown.
6-52