Vco - Uhf Reciter - Tait TB8100 Service Manual

Modulation Based
on Varicap Diodes
Low Noise Amplifier
Harmonic Filter
Fixed Slope
Attenuator, Final
Driver and Fixed
Attenuator
2.5.4

VCO - UHF Reciter

High Q VCO
52 Reciter Circuit Description
Modulation on the VCO is provided by an auxiliary varicap-based control
circuit which provides a modulation gain of 5kHz/V
A BJT cascode amplifier is used as a broad band isolator and low noise
amplifier. This has internal self-bias circuitry, and the output provides
enough RF power to drive the following stages.
The VCO has a relatively high harmonic content. A third order low pass
elliptic filter is used to attenuate this content.
A silicon BJT is used as a broad band matched Class A final driver to drive
the +20dBm local oscillator port of the mixer. To maintain a fixed output
level, a fixed slope attenuator is introduced at the input to the final driver so
that the attenuation rate (slope) increases with an increase in frequency. A
fixed attenuator provides a signal level of +11dBm ±2dB to the input port
of the PA, providing better reverse isolation.
The B-band VCO frequency spans from either 136MHz to 156MHz, or
148MHz to 174MHz, according to the product type.
The C-band VCO frequency spans from either 174MHz to 193MHz, or
193MHz to 225MHz, according to the product type.
Refer to "Identifying the Reciter" on page 70
reciter product types.
The exciter VCO consists of a high Q VCO, modulation based on varicap
diodes, low noise amplifier, harmonic filter, fixed slope attenuator, final
driver and a fixed attenuator.
Note that the K-band reciter uses two VCOs (refer to
page 50), with the appropriate VCO stage being selected for operation
according to the frequency of the channel in use. Only one VCO can be
operational at any one time.
The VCO BJT transistor operates in a common collector, Colpitts oscillator
configuration, and uses a shorted quarter-wave ceramic coaxial resonator.
The open end of the resonator is terminated by a combination of a high Q
trimmer and varactor diodes. This forms a high Q resonator which is both
mechanically and electronically tunable. Mechanical tuning is possible by
adjusting the trimmer. Changes in the control voltage from the loop filter
are applied to the varactors to facilitate electronic tuning.
.
p
for more information on
Figure 2.11 on
TB8100 Service Manual
© Tait Electronics Limited September 2006