Tait TB8100 Service Manual page 266

Reprogramming
and Recalibration
266 Power Management Unit Card and Board Replacement
If you have changed the configuration of the PMU by fitting or removing
an auxiliary power supply board, you will have to reprogram the PMU as
described in the table below.
Procedure
reprogram the product code
a. To reprogram this information into the PMU, you will need to use a dongle with the
Calibration Kit.
There is no need for any recalibration when this board is fitted, removed or
replaced.
Details
use the Calibration Kit to reprogram the
PMU with the product code which
corresponds to the new configuration of the
a
PMU ; for more details refer to
the PMU" on page 217, and to the
Calibration Kit documentation
© Tait Electronics Limited September 2006
"Identifying
TB8100 Service Manual