Figure 10.5 Replacing The Control Board - Tait TB8100 Service Manual

Figure 10.5 Replacing the control board
c
d
b
5W & 50W PA
Reprogramming
and Recalibration
TB8100 Service Manual
© Tait Electronics Limited September 2006
d
f
e
If you have replaced the control board, you will have to reprogram and
recalibrate the PA as described in the table below.
Procedure
reprogram the product code
reprogram the PA type
reprogram the serial number
calibrate the stage bias
calibrate the forward and reverse
detector bias voltages
calibrate the PA output power
a. To reprogram this information into the PA, you will need to use a dongle with the Cal-
ibration Kit.
b
100W PA
c
Details
reprogram this information into the PA using
a
the Calibration Kit ; refer to the Calibration
Kit documentation for more details
carry out these procedures using the
Calibration Kit; refer to the Calibration Kit
documentation for more details
Power Amplifier Board Replacement
d
f
187