Board Replacement - Tait TB8100 Service Manual

8.5

Board Replacement

Replacing Faulty
Boards
Disposing of Faulty
Boards
TB8100 Service Manual
© Tait Electronics Limited September 2006
At certain stages during the fault finding procedure, you will be instructed
to replace a particular circuit board. In these cases, go to the appropriate
section in "Power Amplifier Board Replacement" on page 179
out the board replacement procedures described there. The full procedure
will normally involve:
removing the faulty board
fitting a new board
carrying out the specified reprogramming and recalibration tasks
using the Calibration Kit
carrying out the procedures described in
page 170.
Refer to "Power Amplifier Spare Parts" on page 195
of the spares available for the PA.
We recommend that you dispose of faulty boards according to your local
environmental and safety regulations. Otherwise, return them to your
nearest CSO for appropriate disposal.
"Final Tasks" on
for a full description
Power Amplifier Fault Finding
and carry
137