Figure 19.2 Subrack Mechanical Assembly - Tait TB8100 Service Manual

Figure 19.2 Subrack mechanical assembly
Description
b
module retaining clamp
c cable retaining clip
d bottom guide rail
e top guide rail (also used in the bottom corners
when required)
f rear blanking panel
g airflow separator
h subrack
i M4x10mm pan head Pozidriv screw
j M3 hex nut
1) M3 spring washer
1! receptacle for quarter-turn fastener
1@ subrack ground connector
1# 9.5mm P-clip
1$ insulating foam
1% insulator for interconnect board - single base station
insulator for interconnect board - dual base station
1^ interconnect board
Note:
The characters XX in an IPN (Tait Internal Part Number)
stand for the issue number of the part. Only the latest
issue of each part will normally be available for ordering
as spare or replacement parts.
Note:
This drawing shows a single base station subrack. Any
differences between the single and dual base station
subracks are indicated in the description of the parts.
Parts which are unique to the multi-reciter subrack are
shown in Figure 19.5 on page 293.
IPN
303-50102-XX
303-50104-XX
c
307-02052-XX x5
307-02053-XX
e
316-06785-XX
316-06816-XX
318-01051-XX
345-00050-07
352-00010-08
353-00010-12
354-01049-XX
356-00010-61
357-00010-48
362-01037-XX
362-01121-XX
362-01123-XX
1#
j
x3
1)
x3
1^
1%
1$
g h
b
i
290 Subrack Servicing
1@
f
d
1!
x2
TB8100 Service Manual
© Tait Electronics Limited September 2006