Replacing The Speaker - Tait TB8100 Service Manual

18.4

Replacing the Speaker

Removal
Refitting
282 Control Panel Servicing
The circled numbers in the following instructions refer to
1. Remove the circuit board as described in
Board" on page
2. Remove the M3 nuts and spring washers
c
brackets .
3. Remove the speaker.
1. To refit the speaker, follow the removal instructions in reverse order.
Tighten the M3 nuts to the correct torque.
Important
Make sure the speaker is correctly aligned as shown in
Figure 18.3
board (refer to
2. Refit the board as described in
page 279.
279.
so that the wire will fit through the slot in the
Figure 18.1 on page
"Replacing the Circuit Board" on
© Tait Electronics Limited September 2006
Figure 18.3.
"Replacing the Circuit
b
and then remove the
280).
TB8100 Service Manual