Figure 19.5 Cables And Mechanical Parts Used In The Multi-Reciter Subrack - Tait TB8100 Service Manual

Figure 19.5 Cables and mechanical parts used in the multi-reciter subrack
Description
b
bottom guide rail for reciter fitted in subrack
position 7
c retaining clamp for securing subrack interconnect
board
d DC power cable - PMU to subrack interconnect
board
e system control bus ribbon cable - reciter and PMU
to subrack interconnect board
f DC power cable - subrack interconnect board to
reciter
g insulator for subrack interconnect board
h DC power cable - subrack DC input terminal block
to subrack interconnect board (when no PMU fitted)
i DC input terminal block (when no PMU fitted)
Note:
The characters XX in an IPN (Tait Internal Part Number)
stand for the issue number of the part. Only the latest
issue of each part will normally be available for ordering
as spare or replacement parts.
Note:
This drawing shows the cables and mechanical parts
which are unique to the multi-reciter subrack. All other
mechanical parts are as shown in Figure 19.2 on
page 290.
TB8100 Service Manual
© Tait Electronics Limited September 2006
IPN
307-02054-XX
302-10066-XX
219-03069-XX
219-02858-XX
219-03068-XX
362-01135-XX
219-03067-XX
240-04030-03
b c d e f g
h
i
Subrack Servicing 293