Board Replacement - Tait TB8100 Service Manual

3.4

Board Replacement

Replacing Faulty
Boards
Disposing of Faulty
Boards
TB8100 Service Manual
© Tait Electronics Limited September 2006
At certain stages during the fault finding procedure, you will be instructed
to replace the system interface board. In these cases, go to
Replacement" on page 103
described there. The full procedure will normally involve:
removing the faulty board
fitting a new board
carrying out the specified reprogramming and recalibration tasks
using the Calibration Kit
carrying out the procedures described in
page 95.
Refer to "Reciter Spare Parts" on page 109
spares available for the reciter.
We recommend that you dispose of faulty boards according to your local
environmental and safety regulations. Otherwise, return them to your
nearest CSO for appropriate disposal.
and carry out the board replacement procedures
for a full description of the
Reciter Fault Finding
"Reciter Board
"Final Tasks" on
75