Figure 8.15 Test Equipment Set-Up For The Boost Regulator Board; Figure 8.16 Location Of Test Points On The Boost Regulator Board - Tait TB8100 Service Manual

Figure 8.15 Test equipment set-up for the boost regulator board
12V PA
Figure 8.16 Location of test points on the boost regulator board
b
TB8100 Service Manual
© Tait Electronics Limited September 2006
3. Once connected to the base station, ensure it is in Run Mode.
4. Select Alarms > Current Alarm Status and check there are no alarms.
If there are, go to
alarms, go to "Final Tasks" on page
Boost Regulator Board
"Control Board" on page
170.
c
d
Power Amplifier Fault Finding
148. If there are no
12.5VDC
e
169