Tait TB8100 Service Manual page 105

Reprogramming
and Recalibration
Board Type
when the replacement
system interface board
is a different type from
the original
when the replacement
system interface board
is the same type as the
original
a. To reprogram this information into the reciter, you will need to use a dongle with the Calibration Kit.
TB8100 Service Manual
© Tait Electronics Limited September 2006
Note
Before tightening the screws, press the board down over the locat-
ing pins so that it is firmly seated against the heatsink. Then
tighten the M3 Torx screws to the correct torque, working from
the centre of the board to the edges.
If you have replaced the system interface board, you will have to reprogram
and recalibrate the reciter. The actual procedures required will depend on
whether or not the replacement board is the same type as the original, as
shown in the table below.
Procedure
reprogram the product code
reprogram the reciter type
calibrate the audio
calibrate the audio
Details
reprogram this information into the reciter
a
using the Calibration Kit
Calibration Kit documentation for more
details
carry out this procedure using the Calibration
Kit; refer to the Calibration Kit
documentation for more details
carry out this procedure using the Calibration
Kit; refer to the Calibration Kit
documentation for more details
Reciter Board Replacement
; refer to the
105