Removing The Front And Rear Panels; Figure 14.1 Removing The Front And Rear Panels - Tait TB8100 Service Manual

14.5

Removing the Front and Rear Panels

Figure 14.1 Removing the front and rear panels
b
c
x4
TB8100 Service Manual
© Tait Electronics Limited September 2006
The circled numbers in the following instructions refer to
1. Remove the M4 Torx screw
converter board.
2. Remove the five M4 Torx screws securing the front panel to the
c
heatsinks and shield
3. Remove the M4 Torx screw
converter board.
4. Remove the five M4 Torx screws securing the rear panel to the
f
heatsinks and shield
5. Loosen the rear panel slightly and remove the fibreglass DC input
h
insulator from behind the DC input terminals. Slide the rear panel
off the heatsinks.
d
Power Management Unit Disassembly and Reassembly
b
grounding the front panel to the AC
d
. Slide the front panel off the heatsinks.
e
grounding the rear panel to the AC
g
.
Figure 14.1.
e
f
x4
g
h
253