Refitting The Front Panel; Refitting The Cover And Airflow Duct - Tait TB8100 Service Manual

9.4

Refitting the Front Panel

12V 28V
9.5

Refitting the Cover and Airflow Duct

Cover
Airflow Duct
(100W PA Only)
TB8100 Service Manual
© Tait Electronics Limited September 2006
The circled numbers in the following instructions refer to
1. Refit the front panel and secure it to the heatsink with the M3 Torx
screws.
2. Insert the SMA connector through the front panel and secure it to the
heatsink and front panel with the four M2.5 Torx screws
3. Resolder the centre pin of the SMA connector
Check that C100 and L100 are still correctly soldered and are not
damaged.
4. On a 28V PA, resolder the +28VDC feedthrough capacitor to the
b
metal strap soldered to the 6W board. On a 12V PA, resolder the
white DC output wire
the red DC output wire
The circled numbers in the following instructions refer to
page 175.
1. Slide the cover into place on the heatsink. Make sure the cover is
seated correctly between the heatsink and N-type connector.
2. Secure the cover with the M3 Torx screws.
Note
Fit the two screws
first, followed by the screws securing the cover to the heatsink.
1. Slide the airflow duct into place on the heatsink and secure with the
M3 Torx screws.
2. Secure the DC input cable to the airflow duct with the P-clip and M3
b
Torx screw .
c
to the feedthrough capacitor, and resolder
d
to the 6W board.
d
securing the N-type connector to the cover
Power Amplifier Disassembly and Reassembly
Figure 9.2.
e
.
f
to the 6W board.
Figure 9.1 on
177