Screw Torque Settings; Removing The Covers; Removing The Front And Rear Panels - Tait TB8100 Service Manual

4.1

Screw Torque Settings

4.2

Removing the Covers

4.3

Removing the Front and Rear Panels

100 Reciter Disassembly and Reassembly
The recommended torque settings for the screws and nuts used in the reciter
are as follows:
Location / Function
securing the side covers to the
heatsink and front and rear panels
securing the front and rear panels to
the heatsink
securing the handle to the front
panel
securing the boards to the heatsink
securing the SMA connector to the
front panel
securing the BNC/TNC connectors to
the rear panel
1. Remove the M3 Torx screws securing the covers to the heatsink, and
to the front and rear panels. Lift off the covers.
The circled numbers in the following instructions refer to
1. Remove the four M2.5 Torx screws
to the heatsink and to the front panel.
2. Desolder the centre pin of the SMA connector
and remove the connector.
3. Remove the two M3 Torx screws
heatsink.
4. Remove the M3 screw
and remove the front panel.
5. If necessary, remove the two M3 screws securing the fan duct
the heatsink.
6. Remove the vent guard clip
Torque
0.5N·m / 4.5lbf·in
0.3N·m / 2.5lbf·in
1.7N·m / 15lbf·in
b
securing the SMA connector
d
securing the handle to the
e
securing the front panel to the heatsink,
g
from the rear panel.
© Tait Electronics Limited September 2006
Driver/
Size
Spanner
T10 M3
T8 M2.5
11mm AF
Figure 4.1.
c
from the RF board
f
to
TB8100 Service Manual