Removing The Front Panel; Figure 9.2 Removing The Front Panel - Tait TB8100 Service Manual

9.3

Removing the Front Panel

12V 28V
Figure 9.2 Removing the front panel
b
28V PA
176 Power Amplifier Disassembly and Reassembly
The circled numbers in the following instructions refer to
1. On a 28V PA, disconnect the +28VDC power feed by desoldering
the feedthrough capacitor from the metal strap
board. On a 12V PA, desolder the white DC output wire
the feedthrough capacitor, and desolder the red DC output wire
from the 6W board.
2. Remove the four M2.5 Torx screws
to the heatsink and to the front panel.
3. Desolder the centre pin of the SMA connector
and remove the connector. Ensure that C100 and L100 are not
affected.
4. Remove the M3 Torx screws securing the front panel to the heatsink
and remove the panel.
Figure
b
soldered to the 6W
e
securing the SMA connector
f
from the 6W board
TB8100 Service Manual
© Tait Electronics Limited September 2006
9.2.
c
from
d
e
x4
f
c
12V PA
d
12V PA