Figure 3.6 Recommended Test Equipment Set-Up For Audio Checks - Tait TB8100 Service Manual

Figure 3.6 Recommended test equipment set-up for audio checks
28VDC
Exciter Output
System Control Bus
(also supplies power
to CTU; not used for
TaitNet RS-232 SIF)
16-way cable
10-32VDC
(TaitNet RS-232
SIF only)
To PC running
RS-232
Service Kit or
Calibration Kit
(not used for
TaitNet RS-232 SIF)
SIF = system interface board
90 Reciter Fault Finding
Reciter
CTU
Note
If the reciter is fitted with a TaitNet Ethernet system interface
board, and the PC is connected to the CTU, run the Service Kit
and connect to the reciter, then power up the reciter. Refer to
TN-1142-AN for full Ethernet connection details.
RS-232
(TaitNet RS-232
SIF only)
Signal Generator
or
Audio Generator
Oscilloscope
Audio Analyser
25-way cable
15-way cable (TaitNet)
TB8100 Service Manual
© Tait Electronics Limited September 2006
External
Reference
Input
To PC running
Service Kit or
Calibration Kit
System Interface
Antenna Input