Refitting The Front And Rear Panels - Tait TB8100 Service Manual

14.8

Refitting the Front and Rear Panels

TB8100 Service Manual
© Tait Electronics Limited September 2006
Refer to Figure 14.1 on page
1. Hold the two modules firmly together and fit the front panel over the
heatsinks. Ensure that the shield remains in place. You may find it
easier to fit the front panel while the PMU is lying on its side. This
way the shield is held in place between the heatsinks.
2. Refit and tighten the five M4 Torx screws to secure the front panel to
the heatsinks and shield.
Note
Make sure that all connectors are correctly located in their respec-
tive holes in the panel before fully tightening the screws.
3. Refit and tighten the M4 Torx screw grounding the front panel to the
AC converter board.
4. Fit the rear panel over the heatsinks.
5. Slide the fibreglass DC input
insulator in behind the DC input
terminals. Make sure it fits into the
slot in the board
located on its mounting tabs in the
c
rear panel .
6. Refit and tighten the five M4 Torx
screws to secure the rear panel to
the heatsinks and shield.
Note
Before fully tightening the
screws, make sure that all con-
nectors, switches and the fibre-
glass insulator are correctly
located in their respective holes
in the panel.
7. Refit and tighten the M4 Torx screw grounding the rear panel to the
AC converter board.
Power Management Unit Disassembly and Reassembly
253.
b
and is correctly
c b
257