Canon FINISHER-C1 Service Manual page 83

8. Delivery Sensor Stationary Jam (24H)
The sheet does not move past the delivery sensor when an equivalent of twice the feeding
length of the sheet has been fed after the delivery sensor turned on.
Jam check
Delivery
sensor (PI3)
Feed motor
(M1)
Delivery
motor (M2)
9. Stapling Tray Sensor Stationary Jam (25H)
a. With Stapling
The sheet does not move past the stapling tray sensor 1 sec after the delivery motor (M2) turned
on.
Jam check
Stapling tray
paper sensor (PI4)
Delivery motor
(M2)
b. Without Stapling
The sheet does not move past the stapling tray sensor 2 sec after the delivery motor (M2) turned
on.
Jam check
Stapling tray
paper sensor (PI4)
Delivery motor
(M2)
c. Job Offset
No check is made for stationary jams using the stapling tray sensor.
10.Timing Jam (05H)
The dilivery signal is sent from the copier while the finisher is not ready to receive a sheet.
COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 2 FINISHER UNIT BASIC OPERATION
Equivalent
of size x 2
Normal
Figure 2-279
1 sec
Normal
Figure 2-280
2 sec
Normal
Figure 2-281
Equivalent
of size x 2
Jam check
Delivery
sensor (PI3)
Feed motor
(M1)
Delivery
motor (M2)
Jam check
Stapling tray
paper sensor (PI4)
Delivery motor
(M2)
Jam check
Stapling tray
paper sensor (PI4)
Delivery motor
(M2)
Jam
1 sec
Jam
2 sec
Jam
2-53