Canon FINISHER-C1 Service Manual page 164

CHAPTER 4 MECHANICAL CONSTRUCTION
7) Loosen the two screws [8] on the stitcher
mount [7].
8) Insert the tool [10] into the staple slot of
the stitcher [9].
9) Shift down the stitcher, and turn the stitcher
gear so that the boss on the tool [11] and
the recess of the mount [12] match; then,
tighten the screws on the mount to fix the
two in place.
4-34 COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
[8]
[7]
Figure 4-137B
[10]
Figure 4-138B
[ 1 1 ]
[ 1 2 ]
Figure 4-139B
[9]