Feeding System - Canon FINISHER-C1 Service Manual

CHAPTER 4 MECHANICAL CONSTRUCTION
II. FEEDING SYSTEM
1. Removing the Swing Unit
1) Remove the tray assembly. (See I-6.)
2) Remove the grate-shaped upper guide.
3) Remove the grate-shaped lower guide.
4) Remove the rear cover.
5) Disconnect the cable [1] coming from the
swing guide inside the harness guide assem-
bly from the connector. (2 locations)
6) Free the harness from the harness stop, and
disconnect the two connectors [2].
4-8 COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 4-201A
[2]
Figure 4-202A
[1]