Canon FINISHER-C1 Service Manual page 159

4. Adjusting the Position of the
Paper Retaining Plate
1) Match the hole [1] in the paper retaining plate
[1] with the boss [2] on the paper retaining
plate fixing plate. (Pay attention. The paper
retaining plate has a face and a back.)
2) Insert the paper retaining plate [3] and the
paper retaining fixing plate [4] through a gap
into the copier, and place them temporarily
on the base. (Check to make sure that the
boss on the paper retaining plate fixing plate
and the hole in the paper retaining plate
match.)
3) Butt the paper retaining plate [5] against the
two screws fitted previously.
COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 MECHANICAL CONSTRUCTION
[2]
[1]
Figure 4-126B
[3]
Figure 4-127B
Figure 4-128B
[5]
[2]
[1]
[4]
4-29