Canon FINISHER-C1 Service Manual page 201

19. E584 (faulty feed motor; detail code 03)
Cause
Safety range switch (MS3)
Shutter closed detecting
switch (MS4)
Finisher controller PCB
COPYRIGHT © 1998 CANON INC.
Step Checks
Check the safety range switch. Is
1
the switch normal?
Is the safety range detecting
2
switch pressed correctly?
Check the shutter closed detecting
3
switch. Is the switch normal?
Is the shutter closed detecting
4
switch pressed normally?
FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 TROUBLESHOOTING
Yes/No
Replace the switch.
No
Correct the mechanical workings.
No
Replace the switch.
No
Correct the mechanism.
No
Replace the finisher controller
Yes
PCB.
Action
6-29