Canon FINISHER-C1 Service Manual page 140

CHAPTER 4 MECHANICAL CONSTRUCTION
2. Points To Note When Mounting the
Swing Unit
Keep the following in mind when fitting the
swinging unit into the finisher frame:
2.1 Swing Unit Inlet Guide and the Buffer
Outlet Roll
Fit the swing guide to the frame, being care-
ful so that the swing unit inlet guide edge 1 will
not ride over the buffer outlet roll [2].
To facilitate the work, insert a screwdriver
[4] into the hole in the side plate of the buffer
unit [3], and work after releasing the buffer unit.
4-10 COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 4-205A
[3]
Figure 4-206A
[2]
[1]
[4]