Canon FINISHER-C1 Service Manual page 155

7) Remove the foot cover [12] of the frame.
(This is to prevent interference between the
foot cover and the clock disk [13] of the
paper retaining plate motor when remov-
ing the saddle unit.)
8) Remove the front side cover [14] and the
rear side cover [15]. (2 screws [16] each)
9) Disconnect the two connectors [17].
COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 MECHANICAL CONSTRUCTION
[12]
Figure 4-118B
[1 4 ]
Figure 4-119B
Figure 4-120B
[13]
[1 5 ]
[ 1 6]
[1 7 ]
4-25