Canon FINISHER-C1 Service Manual page 214

CHAPTER 6 TROUBLESHOOTING
b. Stitcher Alarm
Code Error
01H Stitching
· Stitching operation
error
did not end in 1 sec.
02H Stitching
· The number of sheets
capacity
in the holding area
error
has exceeded 15.
03H Mixed
· Sheets of different
paper sizes
sizes are deposited in
the holding area.
04H Staple
· The staples have
shortage
been pulled out of
the stitcher unit.
· The number of
staples is inadequate.
6-42 COPYRIGHT © 1998 CANON INC.
Condition
· The home position
cannot be detected
within 0.5 sec after
stitching operation
starts; the home
position is detected
within 0.15 sec after
rotating the stitcher
motor in reverse
thereafter. (An error
will be identified if
the home position is
still not detected
within 0.5 sec after
reverse rotation.)
· Upon deposit of the
sheet that causes an
excess.
· Upon deposit of the
sheet that causes the
fault.
· Upon detection of
shortage of staples
except during
stitching operation.
FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
Detection Machine operation
· Stops stitching.
Returns to home
position.
· Prohibits stitching.
· Prohibits stitching.
· Prohibits alignment.
· Prohibits stitching.
· Communicates the
shortage to the
copier.
Resetting
· Remove the jam
staple.
· Remove the sheets
from the holding
area.
· Remove the sheets
from the holding
area.
· Set a new staple
cartridge.